• Transmission data rate up to 11.2Gbit/s per channel
• CFP MSA compliant
• Compliant to IEEE 802.3ba specification for 100GBASE-SR10 links
• Up to 11.2 Gbps per channel bandwidth,
• OTU4 compatible
• 10 channels 850nm VCSEL array
• 10 channels PIN photo detector array
• OM3 Multimode Fiber cable of up to 300m and OM4 Multimode Fiber cable of up to 400m
• MDIO digital diagnostic and control capabilities.
• compliant to CFP MSA Management Interface Specification, Draft 1.4
• TX input and RX output CDR retiming
• Hot pluggable electrical interface
• Power class 1 (<8W max)
• Operating case temperature 0°C to +70°C
• 3.3V power supply
• RoHS 6 compliant(lead free)

• Transmission data rate up to 11.2Gbit/s per channel
• CFP MSA compliant
• Compliant to IEEE 802.3ba specification for 40GBASE-SR4 links
• Up to 11.2 Gbps per channel bandwidth,
• OTU3 compatible
• 4 channels 850nm VCSEL array
• 4 channels PIN photo detector array
• OM3 Multimode Fiber cable of up to 300m and OM4 Multimode Fiber cable of up to 400m
• MDIO digital diagnostic and control capabilities.
• compliant to CFP MSA Management Interface Specification, Draft 1.4
• TX input and RX output CDR retiming
• Hot pluggable electrical interface
• Power class 1 (<8W max)
• Operating case temperature 0°C to +70°C
• 3.3V power supply
• RoHS 6 compliant（lead free）

F-tone’s CFP-100G-LR4 100GE CFP transceiver modules are designed for use in 100 Gigabit Ethernet links over single mode fiber. They are compliant with the CFP MSA and IEEE 802.3ba 100GBASE-LR4. Digital diagnostics functions are available via an MDIO interface, as specified by the CFP MSA and F-tone Application Note AN-2080. The transceiver is RoHS-6 compliant and lead-free per Directive 2002/95/EC, and F-tone Application Note AN-2033.

F-tone CFP 100GBASE-LR4 module supports a link length of 10 kilometers on standard single-mode fiber (SMF, G.652). 100 Gigabit Ethernet signal is carried over four wavelengths. Multiplexing and demultiplexing of the four wavelengths are managed within the device.

CFP 100G Passive Electrical Loopback is used for testing CFP 100G  transceiver ports in board level test. By substituting for a full-featured CFP transceiver, the electrical loopback provides a cost effective low loss method for CFP 100G port testing. The CFP-100G-loopback is packaged in a standard MSA housing compatible with all CFP ports.

F-tone 100/40G CFP test board is designed to provide an efficient and easy method of programming and testing 40/100G CFP modules. It comes with comes with complete operations software and user manual to enable intuitive testing. Host board is electrically transparent as maximum, allowing a more accurate assessment of the modules' performance.